Installation NetIns 5.5 - error message when run Nilogin.cmd

[notre]

After installing NETInstall 5.5 - the installation guide specifies that Nilogin.cmd (to add the path \\servername\sharefolder) need to be edited and run on the client side to install client components.

When doing this I get the following message:

"error when determining the current location
This client has no assigned site. (NICFGPRV.00CB)"

Any idee or suggestions?
many thanks
Francois

[Scott]

Did you go to the properties of your site object and set the site definitions with the correct addresses?

[Ryan.Gray]

That error is not from the nilogin.cmd script.
That kicks off a installation. The problem is the computer your trying to install from can't associate to a NetInstall server. In your NI sites you need to make sure that the computer has a matching site it can associate to.

This is usually done by IP but thats not a rule.

check your install logs find them here:
%USERPROFILE%\Local Settings\Temp

to make that work start->run and past that line.

There is a lot there, you might find it easier to work with to delete all temp data there then run nilogin.cmd again and see what happens.

Enjoy,
Ryan